I asked for the white balance values in HDR mode of the sony xr a90k model, I saw that in your calibration there is only one image for HDR (only the basic colors), should I enter only that or also ‘multi point’ and ‘per color’? and another question, is it normal that once these values are entered the black is no longer completely black but becomes a very dark gray? does it perhaps have something to do with the fact that you use gamma 2.2 as a standard?

So, why did I value “hdr white point” on the Sony XR A90K TV?

Please …answer me….. :(

Pleaseeee

expert 2 for hdr (do not use multi point settings), ok, so far I understand, but do the settings of the “per color” joke remain valid for hdr too? because if I use only and exclusively the image you put at the end of the settings I have to reset the previous values set on the “per color” tab, and by doing so they are also reset on “expert 1” for sdr. so I leave them for both?

Please…answer me 🥲

hi, probably I explained myself badly because of the translator. in the color settings, we first have the “basic” settings, then below the “multi point” and below that “per color adjustment”. following the calibration instructions you say that for sdr you use “expert 1” and for hdr “expert 2”. this means that if I use the same custom mode I will only have to change between expert1 or expert 2 depending on the content. in the previous messages you told me that for ser I would have to enter all the values for sdr, and for hdr instead I would have to enter the values of that single last image, correct? however when I change from expert 1 to expert 2 (to see the contents in hdr) all the color settings remain, except “multi point” and this is consistent with the fact that you posted only one image for the “basic” joke for the hdr mode. however in this hdr expert 2 mode the same settings remain on the “per color” tab. so the problem is, if you told me that for hdr I have to use only those values of that image, what do I have to do? reset the “for color” tab? because if I reset it it is also reset in sdr mode.

please…someone answer me…..